22 / 44
Manually Lowering the Turntable to the Parking Position
Risk of material damage due to a defect in the electronic controls!
In the event of a defect in the electronic control system, the turntable cannot automatically move to the
parking position. After some disassembly work, the turntable can be manually folded into the park position.
Before manually folding in the turntable, note the following:
►
If you drive to the nearest garage with the turntable raised, drive slowly and remember that the vehicle is
+99 cm
higher than usual.
Driving to the nearest garage is safer than manually folding in the turn-
table!
►
Do not attempt to manually fold in the turntable yourself if you are not familiar with repair work. Contact
a technician or try to fi nd a technically skilled person.
►
Have the turntable recalibrated by an authorised garage after it has been manually folded into the
parking position.
Risk of severe injuries when disassembling the turntable on the vehicle roof!
►
Do not hold onto the turntable, as the rocker will come free during disassembly.
Risk of severe injuries from moving or falling parts or crushing!
When removing the screws from the turntable, the rocker may come loose very suddenly.
►
Before uninstalling the turntable, always disconnect it from the power supply.
►
Secure and support the turntable to prevent it from tipping over.
Observe the
Safety Instructions and General Notes, p. 7.
1. Lever out the plastic cap in the centre of the axle using
a narrow fl at-bladed screwdriver.
→
You will see an M8 hexagon head screw (width
across fl ats 13 mm).
2. Remove the M8 hexagon head screw using a socket
wrench (width across fl ats 13 mm).
→
Another thread becomes visible.
3. Screw an M12 x 40 screw (minimum length: 40 mm)
into this thread.
→
The rocker on the cone of the tapered shaft is
loosened and the locking mechanism is released.
Damage on the unit!
►
Screw in the M12 screw only as far as is
necessary to loosen the rocker on the
cone of the tapered shaft.