14
15
Product Installation and Assembly
Assembly of the Base
85KG
Remove the base frame
marked with a sticker
"5", and set it aside for
assembly.
Lift up the base which
weighs approximately
85kg and
place it on a flat surface
at least 60cm away from
the wall.
The side with sticker "1"
should face forward, as
shown in the picture.
If you need to place the
device on easily scratchable
s u r f a c e , i n s e r t a m a t
underneath or use other
protective measures to
avoid damage to your floor.
Once the base is set up,
place the level in the center;
if the bubble inclines to the
sides, use the open-end
wrench in the toolbox to
adjust the foot screws and
measure again until the
base is perfectly leveled for
an optimum experience.
Assembly of the Back Support
Due to necessary quality control testing in the factory, minor scratches may be
found on component connections but they will not affect the normal operation of
the device.
Take out the large hex Key/
allen key from the toolbox
and remove the four screws
t i g h te n e d at t h e ba s e
frame’s foot on two sides
and put them aside.
Take out the supporting rod
marked with sticker "2" and
insert it into the vertical
tube on the left side of base
with sticker "1".
Take out the supporting rod
marked with sticker "3" and
insert it into the vertical
tube on the left side of base
with sticker "1".
Lift up the hose a little bit so
as to insert the supporting
rods to the very bottom.
To complete this procedure,
you need to make sure that
the top of the hose aligns
with the surface of the
base frame as shown in the
picture.
Secure the height adjuster
by locking it, in case of
accidental falling of back
support when installing.