Sensor charging
cord
USB cable
Power cord
Remove the covers. Items in the
box should be organized as in
the picture.
01
Find protective gloves in the tool
box and put them on, then take
out all the other boxes as shown.
Refer to the packing list for details.
Take out the base(39kg) and
place it on
a
flat surface with the
cable facing the computer.
Connect the power cord to a
socket and the USB cable to the
PC.
03
Stabilizing
feet box
Base plate
Waist harness
box
Back support box
Sensor box
Tool box
Rods
02
15
Download and install KAT Gate-
way (https://www.kat-vr.com/
pages/support). Pair the sensors
(follow the instructions in KAT Gate-
way) and fully charge. (page 20)
04
Mount the inner sensor on the
back-support plate(List: No. 19
screws).
Mount the storage hooks (List:
No. 19 screws) and insert the
supporting rods into the rod
openings on the base.
06
05
(ONLY FOR C2+: Lift the rubber cover
on the bottom). Slightly lift the rods
to align the screw openings. Insert
screws with gaskets(List: No. 15
gaskets, No. 17 screws).
Temporarily, do not tighten.
07
Align the connection plate (mind
its direction) with the screw-holes on
the supporting rods. Install the gaskets
and cap nuts, use the 5mm hexagon
wrench to hold the screws and
tighten the nuts (List: No. 11, No. 13).
Now, tighten the bottom
screws(ONLY FOR C2+: Push the
rubber cover back down). Note:
Tighten well to avoid safety
hazards.
09
08
Summary of Contents for KAT Walk Coord 2
Page 51: ...www kat vr com...