Karma KP12 Series, Owner'S Manual

Page: 22 / 40

14
Figure.5.4.4 Figure.5.4.5 Figure.5.4.6
5.4.4 Adjustment for Lateral Upper Leg Support
There is 3.5 cm being adjustable at one side. And there are 7
segments being adjustable in fore and aft and each segment is
of 3 cm..
1. Pull up and remove the seat. (See Fig 5.4.1.)
2. Unscrew the screws on the seat back and adjust width
fore and aft according to the occupant’s need, and then
tighten the screws. (See Fig 5.4.7.)
5.4.5 Adjustment for Medial Upper Leg Support (Thigh
Separator)
Loose the knob bolt under the seat and adjust fore and aft
according to the occupant’s need and then retighten the knob
bolt. (See Fig 5.4.8.)
Figure.5.4.7
5.4.6 Adjustment for Lateral Trunk Support
1. Remove the cover of the back support. (See Fig 5.4.9.)
2. Loose the screws on the back support plate and adjust the width and height according
to the occupant’s need and then retighten the screws. (See Fig 5.4.10.)
3. Put the cover of back support to its original position
5.4.7 Adjustment for Back Support Angle
The angle adjustment range of back support is 15 degrees measured from the vertical line
without tilt.
1. Pull out the lock pin. (See Fig 5.4.2.)
2. Pull up and move backward to remove the back support. (See Fig.5.4.3.)
3. Unscrew the 8 screws at the upper and lower parts on both sides of the back support
to adjust the back support angle according to the occupant’s need and then retighten
the screws. (See Fig.5.4.11.)
Caution: This adjustment can only be performed by an authorized technician. If you do the
adjustment by yourself, it might possibly cause damage to the wheelchair or result in the
occupant’s injury.