19
5.6 Transferring In and Out
5.6.1 Transferring In
1.
Turn off the power and engage the parking brake.
2.
Flip-up the foot support.
3.
Lower the occupant into the seat, and use the arm support for support.
4.
Restore the foot support.
5.6.2 Transferring Out
1.
Make sure that the chair is near your final destination.
2.
Turn off the power and engage the parking brake.
3.
Flip-up the foot support or/and arm support.
4.
Move your body to the destination.
CAUTION:
Never stand on the foot support when getting in or out of the chair.
6. BATTERIES AND CHARGER
CAUTION:
Before you attempt charging, ensure you read and understand the instruction manual supplied
with the battery charger, and you choose the correct input voltage for battery charger.
6.1 Charging the Batteries
Charge your batteries if any of the following conditions occur.
1.
If you have used your wheelchair for more than an hour continuously;
2.
You've used more than one third of the total charge;
3.
When you haven't used the wheelchair for more than two weeks;
4.
If the current charge is not enough to reach your final destination
Be sure to follow the procedures precisely listed below.
1.
Turn the wheelchair OFF.
2.
Connect the charger's cord to a power outlet.
3.
There are two charging sockets: one is at the front of controller and another is at the
battery pack. (See figure 6.1 and 6.2.) Then connect the charger's plug to the charging
socket.
4.
The charger's orange LED will light up as soon as the charging starts. The charging time
is at least 6 hours, but it could be as long as 10 hours, depending on the status of the
batteries and temperature.
5.
The orange LED will change to green when the charging is completed
6.
Disconnect the cord and pull out the round plug from the charging socket.
Summary of Contents for KP12 Series
Page 1: ...Powered Wheelchair Owner s Manual KP12 Series KP 12 KP 12T...
Page 2: ......
Page 13: ...5...
Page 39: ......