N.B. This equipment must be installed by a competent person.
Instructions for:
VB499/VB500
Milton Shower Chair
190 kg (30 st.) weight limit
VB501
Luton Shower Chair
190 kg (30 st.) weight limit
VB648/VB506/VB650
Hythe Shower Chair
190 kg (30 st.) weight limit
VB507
Charing Shower Chair
190 kg (30 st.) weight limit
VB510
Darenth Shower Chair
190 kg (30 st.) weight limit
VB511
Round Adjustable Shower Stool
115 kg (18 st) weight limit
VB509
Rochester Shower Stool
190 kg (30 st.) weight limit
VB508
Dartford Shower Stool
190 kg (30 st.) weight limit
VB635
Strood Shower Stool
159 kg (25 st.) weight limit
VB636
Pembury Corner Shower Chair
159 kg (25 st.) weight limit
UU
Do not
UU
exceed the weight limit stated – doing so could put the user at
UU
risk
UU
.
Fixing and Maintenance Instructions
Shower Chairs
09/11/10
996
1. All Shower Chairs/ Stools
Please examine your shower chair for any visible damage before using. If you see any damage or suspect a
fault, please contact your supplier.
In this case, please do not use your product as it may compromise your safety.
U
2. Cleaning
All of the product components are manufactured from quality materials. However, it is very important that
you only clean your shower chairs and stools using a non-abrasive cleaner or mild detergent with a soft
cloth avoid using lime scale remover. Abrasive cleaners e.g. AJAX and or abrasive cleaning pads will
seriously damage your product beyond repair.
Certain products have clip on/clip off backs and/or seats, you can easily remove these if required, clean with
a mild detergent and soft cloth in a warm water solution. Do not exceed 50
o
C when cleaning the seat cover
and/or back as this will permanently damage the plastic.
N.B. Regular daily cleaning will reduce the build up of limescale on your product.
Under No Circumstances use any abrasive cleaners or materials on any of the components. Also check that
the cleaner you intend to use is suitable for ABS, Vinyl, Polymer Plastics and Thermo plastic rubbers and
Polyurethane Rubber.
3. Adjustments to Extension Legs
Remove the ‘E’ clip from the extension leg and extend all four legs evenly to the desired height ensuring
you do not exceed the last punched hole of the extension leg. (see fig. 1)
Once you have achieved the desired height; reinstall the ‘E’ clip, ensuring that it has passed through the
extension leg and is fitting neatly and snug around the outside leg. (see fig. 2).
Never install the extension legs unevenly or slanting, this will compromise the safety of the user.
