EVM Modules of the MS Series Technical Introduction and User’s Guide
52
Notes:
1.
You will start to listen to the messages in succession. In case you
receive the dial tone again, that means you have no recorded messages.
If the EVM is busy at that moment, then the system emits music on hold
or if the music is not active, silence. In that case, you can wait until a
channel of EVM becomes available and it is connected to you or you can
hang up and try again after a while.
2.
If you do not press any key, then you listen to the messages one after
another in a row and you receive the dial tone after the last message.
3.
During the listening operation:
-
If you dial
0,
then
you return to the beginning of the message you are
currently listening to.
-
If you dial
1,
then
you proceed to the next message.
-
If you dial
2,
then you return to the point that is about 3-3,5 sec
earlier and you go on listening to the same message.
-
If you dial
3,
then, starting from the moment you are in, the voice
level of the message is increased by one unit and you go on listening
to the message.
-
If you dial
4,
then
you go to the point that is about 3-3,5 sec later and
you go on listening to the same message.
-
If you dial
6,
then
starting from the moment you are in, the voice
level of the message is decreased by one unit and you go on
listening to the message.
-
If you dial
8,
then you lock the message you are listening to at that
moment (if you have the required authorization) so that it is not
erased until you listen to it again, and then you proceed to the next
message.
-
If you dial
9,
then you erase the current message and proceed to the
next one.
4.
Any message left for you is automatically erased
15 minutes
after it is
listened to.
PDF created with pdfFactory Pro trial version
