EVM Modules of the MS Series Technical Introduction and User’s Guide
44
You can enter the programs by following the order below:
v
Erase the entire ACD messages. (86444)
v
Record the messages in succession. (864+P+Message) or
(8640+P+Message)
v
After recording each message, play back the messages for checking.
(8643+M)
v
If you want to construct single-key menus, then do that as it is explained
in the program “ACD Single-Key Access.”
v
Determine the lines to be answered by the EVM through the program
“DISA/ACD Line Selection*.” (*Please refer to the MS Series
Programming Guide).
v
Mark the extensions that you do not want to be called directly through
the program “Inaccessible Extension Over The DISA/ACD Line*.”
(*Please refer to the MS Series Programming Guide).
v
If there are lines that may receive fax calls, then define them as “Fax
Forwarding Mod 1*.” (*Please refer to the chapter Line Parameters / MS
Series Programming Guide).
v
If you would like the EVM to be on and off line at certain times, then
determine those times by the program “Automatic ACD.”
v
Put the ACD on line.
v
If there is a DRAM module on the EVM, then clear the DRAM memory by
the code “86499”.
Your EVM is ready for use after completing those steps.
PDF created with pdfFactory Pro trial version
