EVM Modules of the MS Series Technical Introduction and User’s Guide
48
In order to activate the message to be used in case of no answer:
H
Lift the handset and hear the internal dial
tone.
7376
Dial 7376
G
Replace the handset.
Notes:
1.
While there is already a permanent message, if 7372 is dialed, then the
permanent message that has been recorded before is erased and a new
one may be left after receiving the signal. In that case the calling parties
hear the message that has most recently been recorded.
2.
The operation principle of this service is the same as that of the service
8648. If both of the messages are present and active, then the calling
party hears the message recorded by 8648. The permanent message you
record is erased in case of blackouts. If the permanent message is
active, then, every time you pick up your phone, the system message
“Absent Message” is announced.
3.
If extension has activated 737 5 or 737 6, while listening to the message
the calling party can:
a)
Press 1 in order to enter extensions queue if the calling party is an
extension.
b)
Press 2 in order to leave a message if the calling party is an
extension, a transferred caller or a caller through ACD/DISA lines.
4.
If the calling party is an external number that is directly ringing on this
extension, he must wait until the end of Permanent Absent Message.
Then after hearing a “beep” tone, he can start leaving a message to the
extension.
PDF created with pdfFactory Pro trial version
