24
English
6
Requirements for operating the WRS
200
Note
Please consult Kärcher-Service in the case of any uncer-
tainties or questions.
●
A suitably large water tank should be available in order
to use the WRS 200.
●
The water tank must be safely fastened to the rear of the
vehicle.
●
Attention must be paid to the maximum permissible
weight and permissible axle loads of the vehicle when
selecting the water tank.
●
According to the attachment guideline, the outer edges
must not protrude more than 400 mm beyond the con-
tour of the vehicle. This is not conformant when no ad-
ditional attachments are mounted (not permitted).
●
Platform C and D
When the WRS 200 is mounted on the rear of the vehi-
cle, a counterweight must be mounted on the front bar
of the WR 100 Adv (weed elimination accessory) or an-
other suitable counterweight must be mounted.
●
Platform E (MC 250)
ATTENTION
Operation with the WRS 200 is only permitted in com-
bination with the interchangeable frame (4.059-478.0).
Due to the maximum axle load of the vehicle, the waste
water tank of the vehicle cannot be used and is automati-
cally opened and forcibly emptied via software settings
when WRS mode is selected. The waste water tank al-
ways remains open when the WRS 200 is in operation.
Furthermore, when using the WR100 Adv, additional
weights may not be used in the front area due to the axle
loads.
Depending on the vehicle certification, a trailer coupling
must or must not be attached. Existing fastening elements
are to be used.
7
Attach the adapter to the vehicle
(platform C, D)
The adapter with coupling triangle is attached to the rear of
the vehicle for mounting the WRS 200.
1
Adapter with coupling triangle
2
Bolts with spring pins (2x)
3
Screws (2x)
1. Push the adapter into the mounting frame of the vehicle,
observing the position of the various vehicles.
Figure: Installation on an MC 130 secured with a bolt and
spring pin
1
Adapter
2
Vehicle mounting frame
3
Position MIC 35/42 (platform C)
4
Position MC 130 (platform D)
5
Metal strip (2x)
Note
Required for installation on an MC 130
2. MIC 35/42: Slide the adapter into the position (first or
second hole) and secure it on the left and right with bolts
and spring pins.
3. MC 130: Fasten the metal strip at the bottom of the
adapter. Slide in the adapter as shown in the illustration
(third hole) and secure it on the left and right with bolts
and spring pins.
4. Tighten the screws to fasten the adapter firmly in place.
8
Fitting the adapter to the vehicle
(platform E)
The adapter with coupling triangle is attached to the rear of
the vehicle for mounting the WRS 200.
1
Adapter plate
2
M10x35 screws and washers (8x)
3
Trailer coupling (optional, depending on certification
type)
4
Adapter plate with coupling triangle
1. Dismantle the adapter plate with the trailer coupling on
the vehicle (8 screws and washers).
2. If necessary, fasten the existing trailer coupling to the
adapter plate with M10x45 screws, washers and nuts
(4x).
3. Hang up the adapter plate with the coupling triangle in
the same way as above and fasten with 8 screws and
washers.
