![background image](http://html1.mh-extra.com/html/karcher/k-4-94-m/k-4-94-m_manual_655022010.webp)
10
English
For connection values, see type plate/technical
data.
Observe regulations of water supplier.
"
Use a fibre-reinforced hose (not included)
with a standard coupling: - Minimum diame-
ter, 1/2 inches (13 mm). - Minimum length,
7.5 m.
"
Screw the coupling unit (supplied) to the water
connection on the appliance.
"
Push the water supply hose onto the coupling
unit, then connect it to the tap.
몇
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage the
HP pump.
If the water supply is not clean, the Kärcher water
filter must be used (special accessory).
When fitted with the appropriate accessories, this
high-pressure cleaner can draw in surface water,
e.g. from water butts or ponds (max. suction
height 0.5 m).
"
Use the Kärcher water filter to protect the HP
pump and accessories (special accessories).
This filter removes dirt from incoming water.
"
As the standard coupling system is not suita-
ble for use in suction mode, the Kärcher suc-
tion hose with integrated filter should be used
instead (special accessory) and suspended
inside the water butt.
"
Remove air from appliance before operation:
Switch on the appliance when the HP hose is
not connected and run it until the water which
discharges from the HP outlet is free of
bubbles. Switch off appliance and connect
HP hose.
"
Screw HP hose on to HP outlet on appliance.
"
Push the appropriate spray lance on to the
handgun and fasten it by turning it to the right
through 90°.
"
Open tap.
"
Plug in mains plug.
"
Set main switch to “I/ON”.
"
Press safety catch on the handgun to release
it and pull lever.
몇
Risk of injury
The handgun is subjected to a recoil force when
the water jet is discharged. Make sure that you
have a firm footing and are also holding the hand-
gun and spray lance firmly.
"
Carrying out the most common cleaning ta-
sks.
Operation with detergents is possible with low
pressure (–)
"
for particularly stubborn stains.
Operation with detergents not possible
Note:
DT can only be added in low pressure mode.
All washing brushes supplied by Kärcher are in-
tended for use with DT.
"
Turn the Variopower jet to the lowest pressure
setting (–).
"
Pull the required length of the DT suction hose
from the housing.
"
Place the end the DT suction hose in a contai-
ner with DT solution.
1
Spray a small dose of the detergent on the dry
surface, and allow it to react (make sure the
detergent does not dry up).
2
Wash off the loosened dirt using the high-
pressure jet.
"
Release the lever on the handgun.
"
During breaks, use the safety catch to secure
the handgun lever.
"
During longer breaks (more than 5 minutes),
also turn the appliance off using the ON/OFF
switch.
Water supply
Water supply from mains
Water supply from open reservoirs
Start up
High pressure operation
Spray lance with Variopower nozzle
Spray lance with dirt blaster
Operation with detergent (DT)
DT take-up from container
Recommended Cleaning Method
Interrupting operation