background image

English

 7

STEP 4:

Î

Connect the high pressure nozzle and 
press the hand trigger to begin clean-
ing.

Caution

Dry runs lasting longer than two minutes 
lead to damages to the high pressure 
pump. If the appliance does not build up 
pressure within two minutes, switch it off 
and proceed as instructed in the Chapter 
"Troubleshooting".

Î

Connect the high pressure hose to the 
high pressure connection of the appli-
ance.

Î

Push the spray lance into the trigger 
gun and fasten it by turning it through 
90°.

Î

Completely open the water tap.

Î

Insert the mains plug into the socket. 

Î

Turn on the appliance “I/ON”.

Danger

The trigger gun is subjected to a recoil force 
when the water jet is discharged. Make 
sure that you have a firm footing and are 
also holding the trigger gun and spray lance 
firmly.

Î

Unlock the lever on the trigger gun.

Î

Pull on the lever of the trigger gun; the 
device will switch on.

Note:

 Release the lever of the trigger gun; 

the device will switch off again. High pres-
sure remains in the system.

For normal cleaning tasks.
Not suitable for use with detergents.

Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were 
specifically developed for your appliance. 
The use of other detergents and care prod-
ucts may lead to premature wear and can 
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.

Î

Pull detergent suction hose as far as is 
required out of the housing.

Î

Suspend end of detergent suction hose 
in a container filled with detergent.

Î

Detach spray lance from the trigger 
gun. Work only with the trigger gun.

Note:

 This will mix the detergent with 

the water stream.

Î

Spray the detergent sparingly on the 
dry surface and allow it to react, but not 
to dry.

Î

Spray off loosened dirt with the high-
pressure jet.

Î

Release the lever on the trigger gun.

Î

Lock the lever on the trigger gun.

Î

During longer breaks (more than 5 min-
utes), also turn the appliance off using 
the "0/OFF" switch.

Î

Insert the trigger gun in its holder.

Start up

Operation

Spray lance with high pressure nozzle

Working with detergent

Recommended cleaning method

Interrupting operation

Summary of Contents for K 2.080













Reviews: