Kärcher K 2.080, Operating Instructions Manual

Page: 6 / 12

6 English
Illustrations on Page 3
Illustration
Î Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. a small
screwdriver).
Illustration
Î Connect high pressure hose to trigger
gun.
Î Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Î
Screw the coupling element (supplied)
to the water connection on the appli-
ance.
Î
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
KÄRCHER recommends using the suction
hose accessory (sold separately) Order no.
9.505-779.0.
STEP 1:
Î Connect the suction hose to the water
inlet on the pressure cleaner and drop
the other end into a bucket.
Tip : If you are not using this accessory, coil
a hose into the bucket and ensure that you
only use a standard hose clamp to connect
to the pressure washer.
CLICK FITTINGS MUST NOT BE USED!
STEP 2:
Î Fill up your bucket with water.
STEP 3:
Î Connect the KÄRCHER power cord to
an electricity source and turn on at pow-
erpoint. Make sure the high pressure
nozzle is not connected and turn the
unit on at the ON/OFF switch. Press the
trigger on the gun - the unit is ready for
use once there is a constant water sys-
tem.
Operation
Before Startup
Water supply
Water supply from mains
How to draw water from a bucket when
using a KÄRCHER Pressure Cleaner