Kärcher 1.576-103.0, Manual

Page: 18 / 228

– 6
 Lock parking brakes.
Illustration
 Remove the pressure balancing at the upper end.
 Pull the locks of the placement mechanics up.
 Pull the push handle upward. The container is un-
locked and lowered.
Illustration
 Pull the container out by the handle.
Illustration
 Put the disposal bag over.
 Tightly close disposal bag by means of the closing
strip.
 Remove disposal bag.
 Dispose of the disposal bag according to the local
provisions.
Illustration
 Insert the new disposal bag so that it is snug
against the reservoir wall and the reservoir bottom.
 Pull disposal bag over the container.
 DANGER
Risk of explosion! The electrostatic earthing between
chassis and dirt container via the spring bow must be
ensured.
 Reinsert the container and lock it with the push
handle.
몇 WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the interme-
diate ring or put them near the lifting
mechanism while locking. Lock the con-
tainer by pressing the sliding bow with
both hands.

Plug in the pressure balancing.
 DANGER
The dust that has been collected should be transported
in dust-proof containers. No refilling is permitted. The
waste containing asbestos is to be disposed off accord-
ing to the rules and regulations for waste disposal.
 DANGER
Only persons trained in waste disposal are permitted to
dispose off the dust collection container.
 Lock parking brakes.

Remove suction hose.
 Close the suction connection on the dirt container,
see operation.
Illustration
 Remove the pressure balancing at the upper end.
 Pull the locks of the placement mechanics up.

Pull the push handle upward. The container is un-
locked and lowered.
Illustration

Pull the container out by the handle.
Illustration
 Pull over the safety filter sack.
Illustration
 Pull out the safety sheet.
 Close the safety filter sack using the self-adhesive
flap.
 Pull the safety filter sack towards the rear.
Illustration

Close tightly the opening of the suction connection
of the safety filter sack using the closing lid.
Illustration
 Securely close the safety filter bag with the at-
tached cable tie.
 Remove the safety filter bag.
 Wipe the inside of the container using a damp
cloth.
 Dispose of the safety filter bag in a dust-tight bag
according to the statutory provisions.
Illustration
 Affix a new safety filter bag.
Illustration
 Pull the safety filter sack over the container.
 DANGER
Risk of explosion! The electrostatic earthing between
chassis and dirt container via the spring bow must be
ensured.
 Reinsert the container and lock it with the push
handle.
몇 WARNING
Crush hazard. Never hold your hands be-
tween the dirt container and the interme-
diate ring or put them near the lifting
mechanism while locking. Lock the con-
tainer by pressing the sliding bow with
both hands.
 Plug in the pressure balancing.
Illustration
 Insert 2 flat-tip screwdrivers up to the stop in the fil-
ter casing openings on the suction head.
 Push both flat-tip screwdrivers down and lever out
the filter casing.
 Remove the filter casing.

Remove the supply air filter from the filter casing.
 Install new supply air filter into the filter casing.
 Insert filter casing in the suction head and snap in
place.
 DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
몇 WARNING
Have all checks and works on electrical parts performed
by an expert.
Note: In case of a failure (e.g. filter breakage) the appli-
ance must be turned off immediately. The failure must
be remedied before the appliance is put into operation
again.

Check the receptacle and the fuse of the power
supply.
 Check the power cable and the power plug of the
device.
 Turn on the appliance.
Replace the disposal bag
Replacing the safety filter sack
Replacing the supply air filter
Troubleshooting
Suction turbine does not run
18 EN