116
1
2
3
4
5
6
?
?
Troubleshooting
Problem
Solution
No display LED on the front panel.
Power cord plug in correctly.
No power supply
No Picture
Ensure that the receiver is switched on.
Check connection and correct.
Check channel and video output and correct.
Poor picture quality
Check the signal level, if this is low then try
adjusting the alignment of your dish.
No Sound
Check the volume level of the TV and the
receiver.
Check the mute status of the TV and the
receiver.
Check the connection of audio cord.
Remote Control does not operate
Point remote control directly towards the
receiver.
Check and replace batteries.
Check that nothing blocks the front panel.
Service is not running or scrambled.
Check the whether the Common Interface
module and smart card is correctly inserted.
Check that the smart card is appropriate for
the selected service.
You have forgotten your secret PIN code.
Refer to Change PIN code(Page 55) of this
owner’s manual.
115
13
Motion Detection
An alarm occurs when the motion detection sensor perceives movement in the
partially selected area using the Partial Zone Motion Detection function.
If you press the
Motion Detection
button from the RMCS Viewer, the Partial Zone
Motion Detection for the currently operating server will appear. It detects the
movement of objects within the activating frame.
• This only works in the operating server. If there is
no operating server, the Partial Zone Motion
Detection window will not appear.
Items
Contents
Enable Partial Zone Motion Detection
Set the operation of the sensor for partial
movement.
Sensitivity of Data Range
Set the sensitivity for partial movement. The higher
the value, the higher the sensitivity.
Sensitivity Data Zone
Set it to a low value when it is too light or too dark.
If it is set to a high value, it might cause a
malfunction.
Summary of Contents for KVR-1000
Page 35: ...70 1 2 3 4 5 6 7 69 ...
