100
1
2
3
4
5
6
7
?
9
Network Configuration
When no router is used
For static IP Users
You can connect to this product using a static IP provided by an ISP (Internet
Service Provider). Network configuration items such as IP address, Subnet mask
and Gateway are for normal network configuration, enabling you to use various
functions such as image and other signal transmission. The DNS Server is used to
receive motion images from the administrator’s e-mail using SMTP (Simple
Message Transfer Protocol) when an alarm occurs, or to connect to this product
with the domain name registered in the DDNS server. A network configuration using
a static IP guarantees a stable network flow, so using a static IP is recommended.
Connect this product to a PC using a LAN cable.
Activate the Target Wizard to select the desired product and enter the
administrator ID and password.
Select the IP type as
Static IP
, and enter the IP address, Subnet mask,
Gateway, DNS Server, TCP Port and HTTP Port (Refer to Network in Target
Wizard).
Click the
OK
button or the
Apply
button to apply to the product. It will reboot at
this time so you will not be able to log on for about one minute. Close the Target
Wizard and connect again a few minutes later.
Remove the connection between the PC and this product and connect with a
LAN Cable instead.
99
8
Alarm Setting
If you select Alarm from among the Target Wizard’s items, the alarm setting screen
will appear as shown below. You can send motion images to the administrator’s e-
mail when an alarm occurs at the Motion Detection and Sensor.
Buttons
Descriptions
Motion Detection/Sensor Enable
Set the alarm operation On/Off for the Motion
Detection/Sensor.
Sensitivity
Set the sensitivity to movement (0~100). The smaller the
number, the more sensitive the response to movement.
Send Mail
Set whether or not you send a motion image to the
administrator’s e-mail when an alarm occurs at the Motion
Detection and Sensor.
Summary of Contents for KVR-1000
Page 35: ...70 1 2 3 4 5 6 7 69 ...
