Kanuk Bank, Instruction Manual

Page: 126 / 152

126 Kanuk GmbH • Hauptstraße 131 • 01744 Dippoldiswalde
EN
KanUK DesIGn
imPortant information
KanUK DesIGn
IMPOrtant InFOrMatIOn
Installation site
Keep the following distances from combustible materials, otherwise there is a risk of fire.
Kanuk® Design forward lateral backwards upwards
Bank, Hang, Stand, Tower,
Tube, Wave
100 cm 30 cm 30 cm 75 cm
Kanuk® Design forward
lateral with
*sp
lateral wit-
hout *sp
backwards To the ground upwards
LuTo XV 80 cm 55 cm 90 cm 50 cm 25 cm 75 cm
LuTo VIII 80 cm 40 cm 60 cm 25 cm 0 cm 75 cm
LuTo VIII Tower 80 cm 40 cm 60 cm 25 cm 0 cm 75 cm
* sp = side plate
Errors, misprints and technical changes reserved.
Combustible floor coverings must be fully protected by fireproof material. In addition, this material must be laid at
least 50 cm to the front and at least 30 cm to the side of the firing chamber. Make sure that the subfloor has a load-
bearing capacity suitable for the furnace and, if applicable, the subframe.
note:
Be careful that the stove gets hot during operation, which may result in a burn hazard. Do not touch the
viewing pane and the outer surfaces!
see table
see table
see table
see table
30 cm
50 cm
30 cm
Combustion air supply
For Kanuk® Design stoves, the combustion air supply is sufficient if the room where the stove is installed has at least
one door to the outside or a window. The window/door should be able to be opened and have a cross-section of at
least 150 cm². The installation room should have a volume of at least 4 m³ per kW of nominal heat output.