Page 98 of 101
DWG ID: 181-0101-00A
Date: 2003-09-26
See also: beacon, id, monitor, mrpt, and xmitok
USERS n
(n = 0 - MAXUSERS)
default 1
This command specifies the channels (streams) which may be available to incoming
connect requests. For example, if USERS = 5 then an incoming connect request will
connect to the lowest channel A - E, if any of these channels are in the unconnected state.
If none of the 5 channels are available (all of them are connected), a <DM> packet will
be sent back to the requesting station and the message “*** connect request: (call)” will
be output to your terminal, if permitted. If USERS is set to 0 no one will be able to
connect to you. If you try to set USERS higher than MAXUSERS, the extra is ignored
and the message “USERS LIMITED BY MAXUSERS” will be displayed.
See also: intface, maxusers, and streamsw
VERSION
Immediate
This command causes the TALON to display its model name and current installed BIOS
version number.
VOLTAGE
Immediate
Displays dc input voltage to unit in XX.XX format.
XFLOW {ON | OFF}
default ON
When ON software flow control will be implemented according to the settings of
START, STOP, XON, and XOFF. For normal software flow control set XFLOW ON,
START $11, STOP $13, XON $11, XOFF $13. The TALON expects the computer or
terminal to respond to the flow control characters XON and XOFF, and the TALON
responds to the START and STOP characters from the computer. When XFLOW OFF,
the TALON will only use and recognize hardware flow control lines (CTS and RTS) to