![background image](http://html2.mh-extra.com/html/kantronics/talon-udc-series/talon-udc-series_user-manual_3412850062.webp)
Page 62 of 101
DWG ID: 181-0101-00A
Date: 2003-09-26
default CONVERS
This command controls the communication mode the TALON will be placed in
AUTOMATICALLY after a connect, if NOMODE is OFF. A connect may result either
from a connect request received or a connect request originated by a CONNECT
command. If the TALON is already in Convers or Transparent Mode when the
connection is completed, the mode will not be changed. If you have typed part of a
command line when the connection is completed, the mode change will not take place
until you complete the command or cancel the line input.
See also: canline, connect, convers, nomode, trans
CONNECT call [VIA call1,call2,...,call8]
Immediate
call = callsign of station to be connected to.
call1,...,call8 = optional stations to be digipeated through. A maximum of 8 digipeater
addresses (callsigns or aliases) can be specified. This is referred to as a path.
Each callsign may also have an optional Secondary Station Identifier (SSID) specified as
-n, where n = 1 - 15. The digipeat callsigns are specified in the order in which they are to
relay transmitted packets. The mode set by CONMODE will be entered upon successful
connect, if NOMODE is OFF. If no response to the Connect request occurs after RETRY
attempts, the command is aborted. A timeout message is printed on the display and the
TALON remains in the Command Mode. The station being connected to (call1) may
receive the connect request but be unable to accept connects, in which case a busy
message will be printed to the screen and the TALON will stay in Command Mode.
Connect requests may only be initiated in the Command Mode and the connect will be
established on the current stream.
If a connect is in progress, or already established, the path may be changed by simply re-
issuing the CONNECT command with the desired path. This must be done on the same
stream as the original connect.
CAUTION, packets en route between your station and the reconnected station may be
lost.
If CONNECT is entered with no parameters, the status of the current stream is displayed.
See also: conmode, conok, dbldisc, maxusers, nomode, retry, ring, streamsw
CONOK {ON | OFF}