External Power from your Radio
Step 1.
Determine which ACC Jack to use (refer to the radio
manual) and establish that 200 ma of current at 12VDC
is available.
Step 2.
Determine pin and current from ACC jack.
Step 3.
Obtain connector and wire a cable
Step 4.
Plug the cable in and check to confirm it is working
This concludes the installation of power to your KAM’98. The next topic is
connecting your KAM’98 to your computer.
Connect your KAM’98 to Your Computer
Your KAM’98 and your computer communicate with each other via a serial com-
munication cable connecting the KAM’98’s “Computer” port and a serial (COM)
port on your computer. This connection is shown in the diagram on
page 40.
Your Serial Communication Cable
The serial cable needed to connect your KAM’98 to your computer (a standard
off-the-shelf, RS-232 modem cable) is not supplied with the KAM’98. You will
need to purchase one, or construct one.
Note: You may construct your own cable, using wiring instructions given below.
The two options, purchasing your cable or making it, are covered next.
Installing Your KAM’98
Connect your KAM’98 to Your Computer
User’s Guide
44
KAM’98 v 8.3
Summary of Contents for KAM 98
