Additional Commands for HF Non-Packet
The commands listed below are only available during HF Non-Packet use of the
TNC (and only then are they shown on the Main Menu screen, in a box in the
lower right of the screen).
ALT+T (transmit) = Exit Type-ahead
This command can be used with all the HF Non-Packet modes listed above.
ALT+T sends a CTRL+C T CTRL+M sequence to the TNC. This causes the
TNC to key the radio and transmit the data in the TNC’s buffer. And if the F5
command had been used to put Pacterm in the type-ahead mode (offline), the sta-
tus line will change to show Pacterm as online (ONLIN).
ALT+R (receive) = Return to Type-ahead
This command can be used with all the HF Non-Packet modes listed above.
ALT+R sends a CTRL+C R sequence to the TNC. This will immediately return
the TNC to the receive mode, even if there is still data in its transmit buffer. Data
in the TNC’s transmit buffer will be saved for transmission later.
+
Hint:
See ALT+E if you want to transmit all data in the TNC and then switch to
receive mode.
ALT+E = Return to Receive
This command can be used with all the HF Non-Packet modes listed above.
ALT+R sends a CTRL+C E sequence to the TNC. This will allow the data in
the TNC transmit buffer to be sent and then return the TNC to receive mode.
+
Hint:
Used ALT+R when you want to hold the data in the TNC transmit buffer
and return the TNC to receive mode.
HF Non-Packet Functions (For KAMs Only)
Pacterm v 2.0
KAM’98 v 8.3
93
User’s Guide
Summary of Contents for KAM 98
