SCREENL
n
(n = 0 - 255)
default 0
This value is used to format what is sent to your terminal. A “CR” sequence is
sent to the terminal at the end of a line when n characters have been printed. A
value of zero inhibits this action.
See also:
autolf
SENDPAC
n
(n = $00 - $FF)
default $0D <Ctrl+M> (CR or ENTER)
This command specifies a character that will force a packet to be sent in Convers
Mode. In the Convers Mode, packets are sent when the SENDPAC character is
entered or when PACLEN is achieved.
See also:
cpactime, cr
SLOTTIME
n
(n = 0 - 255)
default 5
+ We recommend that you change the HF default value 5 to 10 when operating
VHF 1200 baud packet.
n specifies the amount of time, in 10 millisecond increments, between successive
tries of the persistence algorithm.
+
Note:
When switching from 300 baud packet operation on HF to 1200 baud
packet operation on VHF/UHF, remember to change the following (HF de-
faulted) parameters: Mark, Space, SWP, Slottime, Persist, Maxframe, Paclen,
Hbaud. See the packet section in the modes of operation chapter for further detail
(page 144).
See also:
persist
Command Reference
KAM’98 Commands
User’s Guide
306
KAM’98 v 8.3
Summary of Contents for KAM 98
