Kantech IoPass SA-500, Installation Manual

Page: 32 / 36

P r o g r a m m i n g I o P a s s ™ - S t e p b y S t e p - Resetting the IoPass Unit to Factory Defaults
32
READY FOR CARD
DOOR OPEN
2. The “Door Open” message is displayed (and
blinking) and will remain on the LCD until the door
is closed properly.
Once the function is enabled in the system, follow this
procedure to use the duress function:
1. Present your card at the reader (skip this step if you
are using mode 2);
2. Key in your PIN or the main password (if mode 2)
immediately followed by the digit [9].
Example:
55559
followed by [#]
3. The door will open normally (access granted) and the
relay will activate for the pre-set period of time.
How to use the Duress Function