INTEGRA ARINC e-NAV
DESCRIPTION, INSTALLATION,
OPERATION MANUAL
PAGE: 7 of 14
REF.: DOC13033
INDEX: B
DATE: SEP 14/2016
© Orolia S.A.S.
4.3.2. Test preparation
CAUTION: On INTEGRA (ER-N) ELT, if both internal and external GPS
sources are available, the internal source is used.
To check the external GPS, make sure that the internal GPS is not
locked. Depending on the sky view, the internal GPS sometimes locks
even before the first burst at 50 seconds.
To make sure that the internal GPS will not lock, obstruct the top of the
ELT to make
sure it doesn’t face the sky.
NOTE: The best way is to wrap the ELT in aluminum or copper foil.
4.3.3. Validation Procedure
NOTE: For ELT operation, refer to the relevant ELT Operation Manual.
1. After having performed all wiring tasks as indicated in
3.INTEGRA ARINC e-NAV CONNECTION,
plug to the 19 Pin male socket of INTEGRA ARINC e-NAV.
2. Connect the 2-Wire RX ARINC Frames cable to the On Board GPS
equipment..
3. Connect the 2-Wire +28 V DC cable to the +28 V DC On Board Power
Supply
4. Connect the DIN-12 connector of the ELT cable to the DIN-12 Plug of
the ELT
4.3.3.1.
SELF TEST
1. Switch the ELT from OFF to ARM.
2. After 5 seconds the LED of INTEGRA ARINC e-NAV switches ON:
GREEN: +28V DC is correct and ARINC Frame is valid,
Red: +28V DC is not correct and/or ARINC Frame is not valid.
3. After 5 seconds, the LED switches OFF
Summary of Contents for INTEGRA ARINC e-NAV
Page 19: ......
