INTEGRA ARINC e-NAV
DESCRIPTION, INSTALLATION,
OPERATION MANUAL
PAGE: 8 of 14
REF.: DOC13033
INDEX: B
DATE: SEP 14/2016
© Orolia S.A.S.
4.3.3.2.
Data Position Check
1. Switch the ELT to ON.
2. 2 tests bursts are transmitted with default position (no position).
3. Wait 50 seconds until the first 406 MHz burst containing the GPS
position is transmitted by the ELT.
4. Read the position data on the Cospas-Sarsat tester.
5.
Check that this position matches the GPS equipment’s position
IMPORTANT: depending on the protocol used, the position
transmitted by the ELT is rounded off to 4 seconds or 4 minutes (see
table below extracted from CS G005 standard):
Identification data
Location
Data
Protocols
Unique ELT Serial Number
4 minutes
User Location
(1)
4 seconds
Standard Location
Aircraft Operator Designator & Serial
Number
4 minutes
User Location
(1)
4 seconds
Standard Location
Aircraft 24-bit Address
4 minutes
User Location
(1)
4 seconds
Standard Location
Aircraft Registration Marking
4 minutes
User Location
Serial Number Assigned by
Administration
4 seconds
National
Location
(1)
NOTE (1): These protocols are not available by default in Kannad e-Prog
Software
6. Switch the ELT to OFF.
7. Disconnect the Cospas-Sarsat tester.
8. Connect the antenna cable to the antenna socket of the ELT.
9. If the aircraft is in operational condition, switch the ELT to ARM;
otherwise keep the ELT on OFF (see
CAUTION
below).
CAUTION: OFF mode must only be selected when the ELT is
removed from the aircraft or when the aircraft is parked for a long
period or for maintenance.
Summary of Contents for INTEGRA ARINC e-NAV
Page 19: ......
