23
Once in the Command Line Interface (CLI) type “telnet” followed by the IP address
of the unit (and the port number if it is non-standard) and then hit “Enter”. This will
connect us to the unit we wish to control.
Note 1: If the IP address is changed then the IP address required for Telnet access will also change
accordingly.
Note 2: The default IP address is 192.168.1.50.
6.9 Serial and Telnet Commands
COMMAND
Description and Parameters
HELP
Show the full command list.
?
Show the full command list.
P0
Turn the unit off (stand-by mode).
P1
Turn the unit on.
ST
Show the unit’s current firmware version and routing status.
FADEFAULT
Reset the unit to factory defaults.
REBOOT
Reboot the unit.
UPDATE
Prepare the unit to update firmware via the USB port. After
inserting a USB thumb drive containing a valid firmware file (*.bin
format) the update process will begin. After completion the unit
will automatically reboot.
QUIT
Log out from the current Telnet session.
Summary of Contents for HDMX44A-18G
Page 35: ...35 ...
