9
1. Place the Heat Roller Unit next to the printer.
2. Lift the Heat Roller Unit and insert the metal tabs on the side of the unit into the card
stacker slots on the side of the printer.
3. After combining the units, be sure all legs are supported on all aspects of the printer and
Heat Roller Unit and the entire unit is level.
4. Insert the cable from the Heat Roller Unit into the options port on the back of the printer.
Tighten the screws.
5. Attach the card stacker into the mounting slots.
6. Insert the power cord into the power receptacle on the rear of the Heat Roller Unit. Plug
the other end into an available wall outlet.
Loading the Laminate Ribbon
The loading process for differing laminate ribbon is the same. Refer to the following steps to
load any type of laminate ribbon:
Summary of Contents for TEAMNisca PR5302
Page 2: ......