Kanematsu Corporation TEAMNisca PR5302, User Manual

Page: 6 / 27

4
The two types of potential power sources are:
100 ~ 120 VAC at 50 ~ 60 Hz, or
200 ~ 240 VAC at 50 ~ 60 HZ.
Once the power source has been identified, you’ll need:
Single phase, 3-wire grounded receptacle.
If an extension cord is used with the Heat Roller Unit, verify it’s rated for a minimum of
125 VAC, 10 Amps or 250 VAC, 10 Amps.
Note If you have any doubt about the correct power source, DO NOT attempt to use
the unit. Contact your authorized reseller for assistance.
Warning Never operate the Heat Roller Unit in a location where the operator,
computer, or Heat Roller Unit could get wet. Personal injury could result.
The Heat Roller Unit must be connected to a grounded electrical power
supply and properly protected against electrical surges and grounding
faults.
Physical Requirements
The PR5302 requires a sturdy platform that can accommodate its weight and physical
dimensions. The Heat Roller Unit weighs 28.7 pounds (13 kilograms). The dimensions are:
Height: 15.75” (400 mm)
Width: 7.08” (180 mm)
Depth: 11.81” (300 mm)
Environmental Requirements
The PR5302 Heat Roller Unit requires the following environmental conditions for optimal
operation:
Operating temperature range of 50° – 95° F (10° – 35° C). To ensure best performance,
temperatures should be in the range of 68° – 77° F (20° – 25° C).
Operating relative humidity range of 35% – 80% non-condensing.