Kane KANE101, Manual

Page: 10 / 48

Page 10
5. USING THE ANALYSER AND ITS FOUR BUTTONS:
Switching
ON the
analyser
Or HOLD
the
readings
Press the button to switch the unit ON outside in
fresh air. This allows the analyser
’s sensors to be
calibrated. This will set CO to zero and CO
2
to around 400
ppm .
At switch on, the analyser beeps four times and displays
the model number. The bottom line counts down from
typically 90 seconds.
When the analyser is running in measurement mode a
quick press of this key will HOLD the reading. Another
quick press will release the readings.
Switching
OFF the
analyser
Press the button to switch the analyser OFF. The
display counts down from 30 with the pump on to allow time
for the sensors to be cleaned or purged with fresh air. If the
probe is connected, make sure both analyser and probe are
in fresh air.
Press / if you want to stop the count-down to off
and return to making measurements.
Using

/

/
Buttons
Once the “on” countdown has been completed:
Use the

/

/ keys to change settings (such as
time and date ) when the rotary dial is turned to MENU.
Use the

key
Press to save readings if memory locations are available.
The display will flash LOG xxx (or FULL) to give the store
location of the saved data.