Kane KANE101, Manual

Page: 29 / 48

Page 29
11. PROBLEM SOLVING
If any problems are not solved with these solutions, contact us or an
authorised repair centre.
Fault symptom Causes / Solutions
•
Batteries not holding
charge.
•
Batteries exhausted.
•
AC charger not giving correct output.
•
Fuse blown in charger plug.
•
Analyser does not
respond to gas
•
Particle filter blocked.
•
Probe or tubing blocked.
•
Pump not working or damaged with
contaminants.
•
Water Trap Bung not fitting tightly.
•
Sensor fault
TROUBLE SHOOTING
Display is totally clear or totally dark
•
Set the rotary dial to MENU switch on and leave unit for five
minutes.
•
Press

three times (listen for three beeps) then press
twice
•
Press

repeatedly
until the display becomes visible again (this
can take up to 20 seconds). Use

and

to adjust the
display's contrast.
•
Press to accept.
The unit will not turn off.
•
Check the CO value is less than 30ppm
Press and hold