Kaltenbach KPS Series, Manual

Page: 88 / 268

KPS SERIES
Operation
M-UK-KPS--06
11/02/03 Page 88 of 138
KALTENBACH
4.10.12.1 General
•
Default stock length
-
The default length for new run entries.
• Min. front piece
-
The minimum front piece [mm].
• Min. end piece
-
The minimum end piece [mm].
• Shear correction
-
Enter a correction to shift the whole pattern to adjust inaccuracy caused by
deforming of the material during shearing.
• Length correction
-
Due to deforming of the material during shearing it is possible that the
products become longer. By filling in this correction the products will be
sheared shorter.
• Punch time up
-
Punch stroke time (upwards)
• Punch time down
-
Punch stroke time (downwards)
• Flange punch time
-
Flange Punch stroke time (f backward).
• Min. waste length at optimize
-
Enter a minimum waste length for the program to take into account during
optimizing, for example the minimum length that can be used afterwards.
• Shear waste for L
-
Blade thickness of the angle shear.
• L Shear uptime in cycle
-
Upstroke time for angle shear during cycle