Kaltenbach KPS Series, Manual, Page: 67 / 268

KPS SERIES
Operation
M-UK-KPS--06
11/02/03 Page 67 of 138
KALTENBACH
•
Input ZW-axis
There are three input modes for the input of the Z- and W-positions:
-
(ABS) Absolute; the measuring has to be filled in from the bottom side of the
profile and the program will measure the distance from the bottom side of the
profile to get a constant distance to the bottom.
-
(SYM FLANGE) Symmetrical-flange; the measuring is counted from the middle
of the profile, in which the middle of the profile is determined by the height of
the flange.
-
(SYM-WEB) Symmetrical-web; The measuring is counted from the middle of the
profile, in which the middle of the profile is determined by the height of the
web.
-
(TOP) Top; (NOT USED) The measuring has to be filled in from the bottom side
of the profile but the machine will calculate this and measures the distance
from the top to get a constant distance to the top.
•
Steel type
Select the type of steel from the summary which are filled in the Feed Manager
A correction factor to the standard supply speed is filled in for each type of steel.
During the processing the supply speed of the drills will be adjusted to the values from
the list.
-
Select the field Steel type
-
In a second window shows a survey of the steel types
•
Shearing angle
Enter the X position of the left upper corner
Enter the Y position of the left upper corner
Enter the X position of the left lower corner
Enter the Y position of the left lower corner
An angle on the right side of the product will only be cut when this is a full angle. This
means that the angle has to overlap the whole width of the material.
When not a full angle entered, the installation will center on two positions so it is
possible to cut the angle later manually.