Kalfire E Series, Installation And Operation Manual, Page: 18 / 32

18
shelf of the design frame to make sure power can
be accessed to complete installation. The product
is now in place.
2. Connect unit to power. Insert the power cable into
the plug on the right side of the product. Then
plug the cable into the socket.
3. Place the Design Bottom Plate with Logs in front
of the product. Use the E-box as support for this.
4. Then connect the connector plug of the Design
Bottom with the E-box.
5. Move the Design Bottom with Log set centred
over the technical box using the guiding cams and
lift the design bottom plate onto the brackets on
the back to secure its place.
The product is now ready for use. Continue with
chapter 5 to start operating the product.
Custom built-in requirements
IMPORTANT!

Place the fireplace on a piece of cardboard or a
rug during assembly to protect the floor from
damage caused by withal parts.

Ensure that the Design bottom plate with
integrated logs is removed before starting the
installation.
 The bottom of the fireplace must always be fully
supported by a flat and horizontal surface.

Do not place any weight on the frame of the
fireplace.

Ensure that the surface on which the product is
placed can support the weight of the product. For
an overview of the weight, consult the table in
section 8.3.

Due to the weight of the fireplace, it is highly
recommended to place and lift the fireplace with
two people.
 It is strongly recommended to anchor the
fireplace to the wall with the included wall anchors
for additional stability and safety.
 The included wall anchors are not suitable for
mounting the fireplace on the wall, only for
anchoring the fireplace and providing extra safety
against tipping.

Ensure that power is accessible to complete the
installation.

If a wired internet connection is chosen, this
should be taken into account during installation.
IMPORTANT!
1
2
3
2
1
1
2