Kalfire E Series, Installation And Operation Manual, Page: 15 / 32

15
IMPORTANT!
The Design Bottom with Log set is made of fragile
material. Therefore, proceed with extreme caution
when installing the Design Bottom with Log set.
2.
Place the Design Bottom Plate with Logs in front
of the product. Use the E-box as support for this.
3. Then connect the connector plug of the Design
Bottom with the E-box.
4. Move the Design Bottom with Log set centred
over the technical box using the guiding cams and
lift the design bottom plate onto the brackets on
the back to secure its place.
The product is now ready for use. Continue with
chapter 5 to start operating the product.
Installing the fireplace with Design Frame
IMPORTANT!

Ensure the Design Bottom with log set is removed
prior to the start of installation.

While assembling the fireplace, place the fireplace
on a piece of cardboard or rug to protect the floor
from damage from withal parts.

Due to the weight of the fireplace, it is highly
recommended to place and lift the unit with two
people.

Ensure that the surface on which the product is
placed can support the weight of the product. For
an overview of the weight, refer to the table in
section 8.3.
Required tools:

Hammer
 Level
 Drilling machine

Socket wrench 10mm / 3/8 inch
 Drills size 8mm or 5/16 Inch

Design Frame with included template, screws and
plugs.
IMPORTANT!
The standard wall anchor set included with the
fireplace is not used for application with Design Frame.
Save the set in case a different setup is desired in the
future.
IMPORTANT!

To determine the final location, place the drilling
template against the wall on which the product is
desired and check for the right placement.

Ensure there is access to power to complete the
installation.
 Ensure the fireplace can be connected to a LAN
cable/network cable if you wish or need to
connect the fireplace in this manner to the
internet. A LAN cable is not included.
4.4.1
Installing the fireplace and Media Wall
1. Use the provided drilling template to mark out the
holes for the wall anchors.
2
1
2
1
3