Kalfire E Series, Installation And Operation Manual, Page: 13 / 32

13
connect the fireplace in this manner to the
internet. A LAN cable is not included.
IMPORTANT!
Note that the Design Bottom with Log set has to be
removed to start installation.
4.3.1 Anchoring the fireplace to the wall
1. Use the provided drilling template to mark out the
holes for the wall anchors. Line the bottom of the
template out with the surface on which the
product is placed and hang on the wall using tape.
2. Once marked, install the wall anchors by referring
to the standard installation conditions for each
wall type referring to the standard installation
conditions for each wall type.
IMPORTANT!

If you are not sure about your wall type, please
ask an expert or your local DIY store for
assistance.
A. Dry wall, masonry, or concrete wall:
Use the provided UX6 plug and 4x45mm cross
recessed countersunk head screw pozidriv
Drill 4x holes of 6mm and insert plugs.
3.
Drill 4x 6mm holes and insert the plugs. Use the
included screws to attach the wall anchor to the
wall. Make sure it is level.
B. Dry wall with wooden frame or wooden wall
3.
Screw 4x45mm screws directly into wooden frame.
CAUTION!
If a LAN cable/network cable (not included) is desired,
lift the device onto the surface and connect it to the
back of the product before hanging the product on the
wall anchors.
4. Lift the fireplace the wall anchors. The product is
now fixed in place.
IMPORTANT!
Ensure the power can be accessed to complete
installation.