Kalfire E Series, Installation And Operation Manual, Page: 12 / 32

12
IMPORTANT!
This fireplace must be plugged into a 230~240V, 50Hz,
11Amp electric supply with the provided power cord.
This appliance must be grounded.
2.
Lift the fireplace over the wall anchors. The
product is now fixed in place.
IMPORTANT!
The Design Bottom with Log set is made of fragile
material. Therefore, proceed with extreme caution
when installing the Design Bottom with Log set.
3.
Place the Design Bottom Plate with Logs in front
of the body frame. Use the E-box as support for
this.
4. Then connect the connector plug of the Design
Bottom with the E-box. This connector allows for
the log set lighting to function with the product.
5. Move the Design Bottom with Log set centred
over the E-box using the guiding cams and lift the
design bottom plate onto the brackets on the
back to secure its place.
The product is now ready for use. Continue with
chapter 5 to start operating the product.
Installing the fireplace with Media Wall

Level the surface on which the fireplace will be
installed.

Ensure the Design Bottom with Log set is removed
prior to the start of installation.

Place the fireplace in its final position before
continuing to set up the fireplace.
 Once you have placed the fireplace, it is highly
recommended that you anchor it to the wall using
the provided wall anchors for added stability and
safety.
 Ensure that the surface on which the productis
placed can hold the weight of the product. For. a
weight overview, check the table in paragraph 8.3.

If the chosen surface is a floor, ensure the floor
consists of non-combustible materials.
 Kalfire is not responsible for damage or injuries
because of the use of improper materials or
installation.
IMPORTANT!
 While assembling the fireplace, place the fireplace
on a piece of cardboard or rug to protect the floor
from damage from withal parts.

Due to the weight of the fireplace, it is highly
recommended to place and lift the fireplace with
two people.

The bottom of the fireplace has to be supported
at all times.
WARNING!
Provided wall anchoring brackets are not suitable for
wall mounting the fireplace, only for anchoring the
fireplace and providing additional safety against
tipping.
Required tools:

Hammer
 Level

Drilling machine

Screwdriver or screwdriver bit (PZ2)
 Socket wrench 10mm / 3/8 inch

Drills size 6mm / ¼ Inch and size 8mm or 5/16
Inch

E-Series Wall Anchors with included template,
screws and plugs
 Media Wall with included template, screws and
plugs
IMPORTANT!
 To determine the final location, place on top of
flat surface large enough to support the complete
bottom of the product. This surface should
preferably be perpendicular to a wall or other flat
surface for support of the back of fireplace.

The bottom of the fireplace must be supported at
all times.

Ensure the fireplace can be connected to the
power grid to complete the installation.

Ensure the fireplace can be connected to a LAN
cable/network cable if you wish or need to
1
3
2
1 2
3
1
2