6. Operation
37
6.4
Operation from Timer and Thermostat mode
For correct control it is important to always keep the remote control
at room temperature; so do not leave it on a cold, stone table or
outside, for example.
The Fairo is set ex-factory without Timer and Thermostat function.
The installer is the only person who can activate these functions in
the installer menu. The following text concerns the Timer and
Thermostat function.
When the Fairo is ignited, the setpoint temperature can be changed in
Thermostat mode. The temperature is then controlled based on the set
setpoint temperature.
In Timer mode two switch-on times can be set for each day of the week,
with the corresponding temperature setpoints. In this case, control will
be fully automatic based on the pre-programmed settings.
Igniting the Fairo
Activate the display by pressing one of the
four keys. Ignite the Fairo by pressing and
simultaneously
and
wait
until
the
“hourglass” has disappeared.
Note: If this is not successful, the Fairo is then in Timer or
Thermostat mode. Select
Manual operation mode,
and repeat the
steps above.
Setting the flame height
Press for a smaller flame (minimum=1) or for a bigger flame
(maximum=15).
Note: If ºC appears in the display after these keys have been
pressed, the Fairo is in Thermostat mode. Select
Manual operation
mode,
and repeat the steps above.
Setting the temperature
Press or to decrease or increase the temperature setpoint.
Note: If no ºC appears in the display after these keys have been
pressed, the Fairo is in Manual operation mode. Select
Thermostat
mode
and repeat the steps above.
1203
xx
30.5 C