Page 10
Operating Instructions Powador-proLOG_EN
S e c t i o n 5 ·
I n s t a l l a t i o n
5 Installation
5.1 Determining the installation location
Install the Powador-proLOG near a telephone or Ethernet
connection and a 230 V grid connection. To prevent damage
to the Powador-proLOG or the building’s electrical system,
keep the following points in mind when you choose
an installation location:
–
The Powador-proLOG must not be installed outdoors
or in damp areas. The unit must be protected from moisture
and direct sunlight.
–
The ambient temperature must be between 0°C and
+55°C.
–
There must not be any building installations (e.g. power, gas
or water lines) around the drill holes.
–
The Powador-proLOG should be placed on a level surface to
prevent damage to the housing.
5.2 Installing the unit
5.2.1 Powador-proLOG
S
The unit is suitable for mounting on a top hat rail (size 35 mm).
To make it easy to attach the housing, use a clamping device
to snap it onto (or release it from) the hat rail.
5.2.2 Powador-proLOG M / XL
The unit is suitable for wall mounting. Use the
sketch below to mark the drill holes.
The distance between the screws on the mounting bracket
and the wall should be approx. 3 mm.
Hang the Powador-proLOG on the screw
heads, and then pull down. Now secure the
Powador-proLOG with a third screw in the lower part of the
unit.
Drill hole sketch (lengths in mm)
5.3 Service fl ap
The Powador-proLOG may only be operated when the ser-
vice fl ap is closed. However, the service fl ap must be opened
for the purpose of connecting the voltage supply, the network
connection (Ethernet) or sensors.
There are two versions of the service fl ap: Spherical closure or
screw-type closure
5.4 Connections
Powador-proLOG M/XL
Powador-proLOG S
5.4.1 Voltage
supply
The Powador-proLOG is powered by an integrated power supply.
The grid connection (230 V) should be protected by a separate fuse
(e.g. B6A). The power supply provides 24 V,
e.g. to power a solar sensor.
Powador-proLOG M/XL
Powador-proLOG S
ATTENTION
The 230 V AC grid connection of the Powador-proLOG
must always be disconnected from the power supply (by
pulling out the plug) before opening the service fl ap
ATTENTION
Always make sure that the service fl ap is closed while the
unit is in operation, i.e. that the spherical closure is fi rmly
in place or that the service fl ap is screwed tight.
115
92
167
225
230
110
217
220
167
92
S
160 mm
11
0
m
m
