InstallatIon InstructIons
MountInG the controller
Install the controller near a 120VAC / 240VAC (International) outlet. Preferably located in a house,
garage or exterior electrical outlet. For ease of operation, eye level placement is recommended. Ideally,
your controller location should not be exposed to rain or areas prone to flooding or heavy water.
The controller can be installed indoors or outdoors and can be exposed to light rain as it is weather
tight. Fasten the controller using the key hole slot positioned externally on the top center and the
additional holes positioned internally under the terminal cover.
electrIcal hooK-uP
Warning:
.
All electrical work must be carried out in accordance with these instructions following all
applicable local, state and federal codes.
Failure to do so will void the controller’s warranty.
.
Disconnect power supply before any maintenance work to the controller or valves is undertaken.
.
Do not attempt to wire any high voltage items yourself, i.e. pumps and pump contactors
or hard wiring the controller power supply. this should be done by a licensed electrician.
Serious injury or death could result from improper hook up. if in doubt consult your local
codes as to what is required.
FIeld wIrInG connectIons
PREPARATION
.
Prepare wire for hook-up by cutting the wires to the correct length and stripping approximately
0.25 inches (6.0mm) of insulation from the end to be connected to the controller.
.
Ensure terminal block screws are loosened sufficiently to permit easy access for wire ends. Insert
stripped wire ends into the clamp aperture and tighten screws. Do not over tighten as this may
damage the terminal block.
.
A maximum of 0.75 Amps may be supplied by any output. Check the inrush current of your
solenoid coils before connecting more than two valves to any one station.
Summary of Contents for RPS469
Page 32: ...30 Spare Watering Planner ...
Page 33: ...31 Spare Watering Planner ...
Page 34: ...32 Notes ...
Page 35: ...33 Notes ...
