Interval day selectIon
Press the
button until the
“interval days”
is flashing.
The DiSplay Will ShoW:
“Interval 1”
will be flashing. This means the controller will
water every day. The display will show how many days
are left before an active schedule.
For example, if it showed
“1”
then in one day’s time the controller will run this program. To change
the interval day, press the
or
button.
Select from 1 to 15 interval days.
nOtE:
When changing the interval day, the next active day is always changed to 1. This means that
tomorrow is the first active day to run.
steP 3 – statIon run tIMes
This is the length of time that each station (valve) is scheduled to water on a particular program.
Maximum watering time is 12 hours 59 minutes for each station.
A station can be assigned to any or all of the possible 6 programs, if required.
Turn the dial to the
“Set Station Run Times”
position.
The DiSplay Will ShoW:
nOtE:
This means that station 1 of program
1 has no run time programmed in it. The controller
has permanent memory so when the device is first used
there will be no run times set. Unlike other controllers,
when there is a power failure, even if the battery is not
installed, the programmed values will be restored to the unit.
ProGraMMInG
Summary of Contents for RPS469
Page 32: ...30 Spare Watering Planner ...
Page 33: ...31 Spare Watering Planner ...
Page 34: ...32 Notes ...
Page 35: ...33 Notes ...