K-Rain RPS469, Instruction Manual

Page: 31 / 36

servIcInG the controller
The controller should always be serviced by an authorized agent.
Follow these simple steps to return the unit:
.
Turn the power OFF to the controller.
a) If the controller is hardwired, a qualified electrician will be required to remove
the entire unit depending on the fault.
b) Return the entire controller with transformer or disconnect the panel assembly only for
servicing or repair.
. Disconnect the 24 VAC leads at the controller 24 VAC terminals on the very left hand side of the
terminal block.
.
Clearly mark or identify all valve wires according to the terminals they are connected to, (1–9).
This allows you to easily wire them back to the controller, maintaining your valve watering
scheme.
. Disconnect valve wires from the terminal block.
.
a) Remove the complete panel from the controller housing by unscrewing the two screws in the
lower corners of the fascia. (both ends of the terminal block)
b) Remove the complete controller from the wall unplugging the lead.
6.
Carefully wrap the panel or controller in protective wrapping and pack in a suitable box and return
to your service agent or the manufacturer.
nOtE:
Tampering with the unit will void the warranty.
.
Replace your controller panel by reversing this procedure.
The controller should always be serviced by an authorized agent.
servIcInG the controller