Instruction Manual
Section Two
HAND POWERED TABLE TRAVEL GRINDERS W I T H BALL TRACK: As soon
as you have received your machine, move the table to the extreme right side
of the machine, and check the level of way lube in the channel area surround
ing the hardened ways in the saddle. This should be maintained near the top
of the overflow space cut into the saddle extension casting. The oil provides
a washing action on the balls, thus keeping them and way contact line free of
dust. Add way lube as necessary. Extra light way lube Part No. 2671 must
be used.
E. Remove the shipping anti-rust lubricant from all non-painted surfaces by using
a standard solvent.
II. COMPLETING ASSEMBLY OF GRINDER COMPONENTS
A. Refer to this manual, pages 96 to 99, or to other grinder literature for correct
standard equipment breakdown. Do the same for any fixtures or tooling which
are not standard with the machine. NOTE: Check all cardboard cartons for
items which are pictured and listed. Check inside of all coolant tanks for parts.
Occasionally standard accessory equipment will be included in these cartons.
B. Pulleys and belts: Place V pulleys on the motor and the quill shafts, using keyed
washers and special nuts. NOTE: CHOOSE PULLEYS ONLY AFTER CON
SULTING THE MACHINE R.P.M. CHART. Visually check the alignment by
rotating the motor shaft by hand or by power with the belt in place.
C. Consult Section Four, Part III, pages 13 to 17 for the installation of wheel and
pulley arbors onto spindle shafts.
D. Hydraulic Machines: See pages 6, 11, 12 of "Instruction Manual" HPL-3 for
installation and trouble-shooting information. See Section Four, Part III, page
11 for operating instructions.
IIl. FOUNDATION AND LEVELING
A. Read any set-up instruction cards on the machine. The base of most models is
supported by four cast pads on the floor and four leveling screws turned into
each corner of the base. If a spirit level reveals that the table is not level,
make adjustments according to machine tags or " B " below,
B. LEVELING: Place leveling pads on floor underneath the bolt locations and
lower machine carefully. Adjust the set screws by wrench on their square
head, inside of base cabinet, and when machine is level, lock the hex jam nut
underneath the cabinet on all four screws. See diagram on page 1. All four
screws must be firmly contacting pads in order for machine to function properly.
C. B300 series grinders have three integral base cabinet pads. Leveling must be
accomplished by placing metal plates under one or more of the pads.
- 1 A -
