XV-M52SL/XV-M50BK
1-19
Solder soldering
a
on the flexible board next to the
pickup unit.
From the bottom of the traverse mechanism unit,
disconnect the flexible wire from CN12 on the pickup
board.
1.
2.
Unsolder soldering
f
and
g
of the harness extending
from the turn table assembly to the pickup board.
Remove the screw
E
attaching the shaft stopper (F)
on the upper side of the traverse mechanism unit.
Pull the side of the shaft stopper (F) outward to
release the joint
i
and remove it upward. Remove the
spring at the same time.
Remove the screw
F
attaching the turn table
assembly.
Move the turn table assembly outward and pull out
from the shaft. Then remove it from the base chassis.
3.
4.
5.
6.
Removing the turn table assembly
(See Fig.1, 6, 8 and 9)
The laser diode of the pick-up might be destroyed by
static electricity, and solder with part a, please before
extracting a flexible wire from connector (CN12).
Moreover, please remove solder in part a after
inserting a flexible wire in connector (CN12).
Please refer to page 1-4 for a detailed content.
ATTENTION
Fig.8
Fig.9
Fig.6
Pickup board
Feed motor assembly
Turn table assembly
Turn table assembly
Shaft stopper (F)
Shaft stopper (F)
Shaft
Shaft
Joint i
Shaft stopper (F)
CN12
f
g
e
Joint h
Joint h
C
E
F
F
E
E
Fig.1
Pickup unit
Flexible board
a
Summary of Contents for XV-M50BK
Page 88: ...XV M52SL XV M50BK 2 17 ...
