XV-M52SL/XV-M50BK
1-17
Solder soldering
a
on the flexible board next to the
pickup unit.
From the bottom of the traverse mechanism unit,
disconnect the flexible wire from CN12 on the pickup
board.
1.
2.
Remove the screw
A
attaching the shaft stopper (R)
on the upper side of the traverse mechanism unit.
Pull the side of the shaft stopper (R) outward to
release the joint
b
and remove it upward. Remove
the skew spring at the same time.
Move the shaft in the direction of the arrow to release
it from the part
c
.
Release the joint
d
with the shaft and remove the
pickup with the shaft.
Pull out the shaft.
Remove the screw
B
attaching the switch actuator.
3.
4.
5.
6.
7.
Removing the pickup (See Fig.1 to 5)
The laser diode of the pick-up might be destroyed by
static electricity, and solder with part a, please before
extracting a flexible wire from connector (CN12).
Moreover, please remove solder in part a after
inserting a flexible wire in connector (CN12).
Please refer to page 1-4 for a detailed content.
< DVD Traverse mechanism section>
ATTENTION
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Pickup unit
Flexible board
Flexible wire
Pickup unit
Shaft stopper (R)
Shaft stopper (R)
Shaft stopper (R)
Skew spring
Shaft
Shaft
Shaft
Pickup
Switch actuator
Shaft
Joint d
Joint b
Part c
Pickup board
CN12
a
A
A
B
Summary of Contents for XV-M50BK
Page 88: ...XV M52SL XV M50BK 2 17 ...
