RX-DV5RSL
1-8
Prior to performing the following procedures, remove
the top cover, rear cover and DSP board.
Pull up the two plastic rivet attaching the DVD / CD
unit dust proof cover.
Remove the DVD / CD unit dust proof cover
attaching on the main board.
Remove the three screws marked J attaching the
DVD / CD unit.
Remove the bracket marked a attaching on the DVD
/ CD unit.
Disconnect the connectors CN512 and CN513 on
the main board.
1.
2.
3.
4.
5.
Removing the DVD / CD unit
(See Fig.15)
Prior to performing the following procedures, remove
the top cover, rear cover, video board, DSP board,
amplifier board, S-video board and fan bracket.
If necessary, cut off the tie band fixing the harness.
Disconnect the card wire from the connector CN115
on the power supply board.
Disconnect the harness connected to the connector
CN111 on the power supply board.
Remove the four screws marked L attaching the
power supply board on the body.
Unsolder the solder points at the three harnesses
connected to the power supply board.
1.
2.
3.
4.
5.
Removing the power supply board
(See Fig.17)
Prior to performing the following procedures, remove
the top cover, rear cover, video board, DSP board,
amplifier board and S-video board.
If necessary, cut off the tie band fixing the harness.
Remove the two screws marked K attaching the fan
bracket on the body.
Remove the harness bands fixing the harness on the
fan bracket.
Disconnect the connector CN122 on the main board.
1.
2.
3.
4.
Removing the fan bracket (See Fig.16)
Fig.15
Fig.16
J
CN512
CN513
Dust proof
cover
J
DVD
/ CD
unit
Main
board
Power
supply
board
Fan
bracket
K
Harness bands
CN122
CN111
Fig.17
Power
supply
board
L
L
CN121
CN111
CN115
CN121
CN115
CN122
Tie
band
Solder
points
Main
board
Bracket a
Plastic
rivet