23
English
IMPORTANT:
When using the Remote Control, check to see if its remote control
mode selector is set to the correct position:
To operate this receiver, set it to “AUDIO/TV/VCR (except when
selecting the DBS tuner as the source).”
Changing the Source Name
When you have connected an MD recorder to the TAPE/MD jacks or the DBS tuner to
the TV SOUND/DBS jacks on the rear panel. Change the source name shown on the
display when you select the MD recorder or DBS tuner as the source.
On the front panel
only:
1. When changing the source name from “TAPE” to “MD”:
• Turn SOURCE SELECTOR until “TAPE” appears.
When changing the source name from “TV SOUND” to “DBS”:
• Turn SOURCE SELECTOR until “TV SOUND” appears.
2. Press and hold LOUDNESS/SOURCE NAME until
“ASSGN. MD” or “ASSGN. DBS” appears on the
display.
To change the source names to “TAPE” or “TV SOUND,” repeat the same procedure
above (in step 1, select “MD” or “DBS” then press and hold SOURCE NAME).
Adjusting the Front Speaker Output Balance
If the sounds you hear from the front right and left speakers are unequal, you can adjust
the speaker output balance.
On the front panel
only:
1. Press BALANCE/SURROUND ADJUST repeatedly
until “L/R BALANCE” appears on the display.
The display changes to show the current setting.
2. Turn MULTI JOG to adjust the balance, while the
indication of the previous step is still on the display.
• Turning it clockwise decreases the left channel
output.
• Turning it counterclockwise decreases the right
channel output.
Listening at Low Volume (Loudness)
Human ears are not sensitive to bass at low volume. To compensate for this, the
loudness function automatically boosts the bass level as you lower the volume.
On the front panel
only:
Press LOUDNESS/SOURCE NAME briefly to select the
loudness function.
Each time you press the button, the loudness function alternates
between “LOUDNESS ON” and “LOUDNESS OFF.”
•
Select “LOUDNESS ON” to activate the loudness function.
The LOUDNESS indicator lights up on the display.
•
Select “LOUDNESS OFF” to cancel it.
The indicator goes off.
Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening
room, while others will make operations easier.
AUDIO/TV
/VCR
CATV
/DBS
Note:
Without changing the source
name, you can still use the
connected components.
However, there may be some
inconvenience.
– “TAPE” or “TV SOUND” will
appear on the display when
you select the MD recorder or
DBS tuner.
– You cannot use the COMPU
LINK remote control system
(see page 59) to operate the
MD recorder.
SOURCE SELECTOR
LOUDNESS
SOURCE NAME
BALANCE
/SURROUND
ADJUST
MULTI JOG
Note:
The loudness function affects
the front speaker sounds only.
LOUDNESS
SOURCE NAME
EN20_51.RX-774R[E]/1
98.3.31, 2:03 PM
23
