JVC IF-2D3D1, Instructions Manual

Page: 8 / 28

06
EN
Adjusting the stereoscopic effect –
monitoring method
You can select a monitoring method when adjusting the stereoscopic effect of a 3D image. In addition to
ordinary 3D representation, anaglyph (the left and right images are colored differently) and LR sequential (the
left and right images are displayed alternately) are available for monitoring and adjusting parallax and intensity.
Setting
Follow the steps below to select a monitoring method.
1
Press ADJUST MODE and select a setting value using .
Monitoring method Setting value Content
Normal
PARALLAX
Parallax and intensity are adjusted using an image displayed in the format selected
in 3D MIX FORMAT.
INTENSITY
SUB INT.
Anaglyph
(ANAGLYPH MODE)
PARALLAX ANA
Parallax and intensity are adjusted using an image displayed in anaglyph. INTENSITY ANA
SUB INT. ANA
LR sequential
(LR-SEQ. MODE)
PARALLAX LRS
Parallax and intensity are adjusted using an image displayed in LR sequential. INTENSITY LRS
SUB INT. LRS
2
Adjust a setting value using . (0 - +60)
Anaglyph
Images for the left and right eyes are colored in red and blue respectively
and displayed on one screen in layers. You can check parallax adjustment by
viewing the gap between the left and right images even on a 2D (conventional)
monitor or without 3D glasses.
●
Be aware that it is difficult to see the colors and stereoscopic effect
correctly in anaglyphic representation.
Images for the left and right eyes are displayed alternately at 0.5-second
interval. You can view images in this method on a conventional 2D monitor
but it requires training to see them as 3D images.
LR sequential
L R L R
Normal 3D images are output as they are. You can adjust images while
viewing them as natural 3D ones by using a 3D-compatible monitor.
Normal
0.5 sec.
0.5 sec.
0.5 sec.
0.5 sec.
2D3D_EN.indb 06 2D3D_EN.indb 06 10.3.1 11:24:44 AM 10.3.1 11:24:44 AM