i
EN
Installation and connection
Accessories
●
Main unit
●
Power cord
●
Power cord holder/tapping screws x 2 (4 mm)
●
EIA rack mounting adapters x 2/tapping screws x 8 (3 mm)
Installation
Read the safety precautions (separate sheet) carefully and install the device properly.
Connecting the power cord and attaching the power cord holder
Attach the power cord holder to the back of the unit to prevent accidental disconnection of the cord.
●
Ground the earth plug of the power cable to the earth terminal of the AC outlet.
●
The holder consists of two parts: the cord case and the case cover.
Cautions
●
Do not use any screws other than those supplied.
●
Push the cover into the case and check that the power plug is connected fi rmly.
Mounting the unit in to an EIA rack
Read the safety precautions (separate sheet) carefully before installing this unit in an EIA rack.
Case
To take off the cover
3
1
AC IN terminal
2
Cover
Take off the feet on the bottom of
the unit.
Attach the EIA rack mounting adapters
with the supplied screws.
●
Fit the screws in order shown.
Install the unit to an EIA rack.
●
Screws for mounting are not
supplied. Use the special
screws for EIA racks (purchased
separately).
1
2
3
2D3D_EN.indb i
2D3D_EN.indb i
10.3.1 11:25:20 AM
10.3.1 11:25:20 AM
Summary of Contents for IF-2D3D1
Page 27: ...vi Index EN V Vectorscope 10 W Waveform monitor 10 ...
Page 28: ......
