JVC CA-EX70, Instructions Manual

Page: 17 / 51

17
CA-EX70
Remote control batteries
Load the supplied batteries (2) into the remote control.
1
Open the battery case.
Push down and pull the lid in the direction of the arrow.
2
Load the batteries.
Insert two R6P(SUM-3)/AA(15F) batteries.
Match the polarity (+ and –) of the batteries with the +
and – marks inside the battery compartment.
3
Close the battery case.
Operating the Remote Control
Point the remote control toward the remote sensor on the front panel. The signal may not reach the
remote sensor if the remote control is used at an angle, or if there are objects between the remote
control and the remote sensor.
Cautions
Observe the following to avoid battery leakage or explosion:
•
If the range or effectiveness of the remote control
decreases, replace the batteries using R6P(SUM-3)/
AA(15F) type dry cells.
• Do not use an old battery together with a new one.
• Do not use different types of batteries together.
• Do not disassemble the batteries or subject them to
high temperatures, like an open fire.
• Remove the batteries if the remote control will not be
used for a long time.
BAND
VOLUME
UP
KEY
MODE
DOWN
INPUT
PHONES
RX-EX70 INTEGRATED AMPLIFIER / TUNER
STANDBY
DIRECT S. A. BASS
POWER
EN01-22.CA-EX70[J]/1-5/21 98.6.8, 9:32 AM 17