Jura ENA Micro 9 One Touch, Instructions For Use Manual

Page: 18 / 136

18
4 Permanent settings in programming mode
4 Permanent settings in
programming mode
Products
J
WARNING
Hot coffee, hot steam and hot water can cause
scalding. Scalding is a serious burn.
T Use extreme care when handling hot liquid
or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area
with cold water and seek medical attention.
T Keep children AWAY.
You can make the following permanent settings for
espresso and coffee:
U
Amount of water:
0.5 OZ
–
8.0 OZ
(25 ml – 240ml) (per cup)
U
Coffee strength:
NORMAL
,
STRONG
U
Temperature:
NORMAL
,
HIGH
You can make the following permanent settings for
latte macchiato and cappuccino:
U
Amount of milk foam:
3 SEC
–
120 SEC
U
Interval:
0 SEC
–
60 SEC
U
Coffee strength:
NORMAL
,
STRONG
U
Amount of water:
0.5 OZ
–
8.0 OZ
(25 ml – 240ml)
U
Temperature:
NORMAL
,
HIGH
You can make the following permanent setting for
hot water:
U
Amount of water:
0.5 OZ
–
15.0 OZ
(25 ml – 450 ml)
Permanent settings in programming mode always
follow the same model.
Example:
Permanently change the coffee strength
(
FLAVOUR
) for espresso from
STRONG
to
NORMAL
.
Precondition:
READY
is displayed.
k T Press and hold the Rotary Switch until
RINSE
appears.
g T Turn the Rotary Switch until
PRODUCT
is
displayed.
k T Press the Rotary Switch to enter the
program item.
SELECT BUTTON
E Next select the button of the product for
which you would like to make settings.
No product is prepared at this point.
< T Press the Espresso button.
ESPRESSO
WATER
g T Turn the Rotary Switch until
FLAVOUR
is
displayed.
k T Press the Rotary Switch to enter the
program item.
STRONG
g T Turn the Rotary Switch until
NORMAL
is
displayed.
k T Press the Rotary Switch to confirm the
setting.
OK
, the coffee strength is set.
FLAVOUR
g T
Turn the Rotary Switch until
EXIT
is
displayed.
k T Press the Rotary Switch to exit the program
item.
PRODUCT
g T Turn the Rotary Switch until
EXIT
is
displayed.
k T
Press the Rotary Switch to exit programming
mode.
READY
Setting the water hardness
E If you are using the CLEARYL Blue filter
cartridge and have activated it in program-
ming mode, you will not be able to adjust
the water hardness.
The harder the water is, the more frequently the
ENA needs to be descaled. It is therefore important
to adjust the water hardness.
The water hardness can be adjusted on a continu-
ous scale between 1° dH and 30° dH.